Structural Description: Standard double-sided perforated hot-dip galvanized steel panels, featuring 0.5mm-thick steel face sheets bonded under high pressure to an asbestos-free, high-density fiber cement core.
Standard Stock Sizes (Commonly used for export shipping containers)
1. 1200 × 2400 mm (Mainstream in the domestic market; optimized for container loading)
2. 1220 × 2440 mm (International imperial standard; preferred by overseas clients)
Total Panel Thickness (Common market specifications)
- 9.5mm (Standard/Primary model): 8.5mm core + 0.5mm galvanized steel sheets on both sides; weighs approx. 21kg/㎡. The preferred choice for most explosion-proof walls, control rooms, and chemical processing enclosures. Offers fire resistance up to 240 minutes (4 hours) and is classified as A1 non-combustible.
- 12mm (Reinforced model): Provides higher blast resistance and load-bearing capacity; designed for high-risk zones and explosion-proof exterior wall cladding.
- 6mm (Lightweight model): Primarily used for explosion-proof ceilings, equipment protective covers, or localized partitions; not recommended for primary explosion-proof wall structures.
> Face Sheet Options: Standard Z275 hot-dip galvanized steel; 304/316 stainless steel available for corrosive environments. Steel sheet thickness can be customized between 0.4mm and 0.6mm.
Customization Options (OEM – for inclusion in buyer quotations)
- Dimensions: Width ≤ 1220mm; length up to 3000mm (lengths exceeding this are generally not recommended due to container transport constraints).
- Perforation patterns, hole diameters, and hole spacing can be customized.
- Surface Finish: Bare (unfinished), primed, or with anti-corrosive coatings.
- Supporting Systems: Explosion-proof framing/studs (100/150/200mm channel steel; wall thickness...) Includes a complete system: 2.0–4.0mm [components/cladding], rock wool infill, explosion-proof angle brackets, and sealing strips.
Total wall system thickness (a common inquiry from overseas general contractors-note that this refers to the complete assembly, not just the individual board thickness):
Two layers of 9.5mm explosion-proof boards combined with 150mm framing (studs) result in a total finished wall thickness of approximately 169mm. Alternative configurations-such as 180mm or 220mm-can also be engineered based on specific blast-pressure requirements.
The 9.5mm (1220×2440mm) specification is the primary choice for export (containerized) shipments; it is readily available in stock, supported by comprehensive test reports, and can be supplied with CE certification. Orders for boards thicker than 12mm require a longer lead time and must be scheduled into the production plan in advance. The boards can be cut and drilled on-site to accommodate utility lines and conduits.
Nov 02, 2026
Leave a message
What Are The Specifications For Explosion-proof Fiber-cement Composite Steel Plates?
Send Inquiry




